Search results for 'Oil'

a – Useable for engine type 447 UL, 503 UL, 582 UL 90/99 and 618 UL;
b – For adjustment and control of the ignition timing;
c - To cover the crankcase;
d – To hold the oil pump gear;
e – To hold the magneto flywheel;
f – For magneto fly wheel;
g – For ball bearing 6206, crankshaft magneto side;
h – For ball bearing 6207, crankshaft;
i – For ring halves;
j – For puller;
k – For crankshaft PTO side;
l – For crankshaft magneto side;
m – For ball bearing

B – Loctite 243
E – Anti-Seize
I – Lithium-Base Grease
O – Engine Oil

a – From engine S/N 582 UL Mod. 90 5,236.549 piston for monohook circlip configuration (see also SI-2ST-001);
b – With 2 rings, standard;
c – With 2 rings, 1st oversize;
d – with 2 rings, 2nd oversize;
e – Standard size;
f – 1st oversize;
g – 2nd oversize; 
h – For use with piston Part No. 888 590 (Also see SI-2ST-001);
i – Use only once

a – For cylinder;
b – For cylinder exhaust flange;
c – For rotary valve shaft;
d – For ball bearing, rotary valve shaft;
e – For oil seal rotary valve shaft (wihout oil pump), intake side;
f – For oil seal rotary valve shaft (with oil pump), intake side;
g – For inner oil seal rotary valve shaft, water pump side;
h – For outer oil seal rotary valve shaft, water pump side;
i – To press in the rotary seal;
j – For rotary valve timing;
k – To pull out the rotary seal - the inner steel bushing of the rotary seal has to be removed before demounting!;
l – For fitting of piston pin circlip;
m – For fitting of piston pin circlip (monohook circlip);
q – To press in the rotary seal 850942 with the insertion jig

A – Loctite 221
B – Loctite 243
C – Loctite 648
D – Loctite 574
O – Engine Oil

a – 582 UL DCDI mod. 99 rotary valve for configuration with rotary seal;
b – 582 UL DCDI mod. 99 the circlip must be positioned at the inner groove only;
e – Crankcase including rotary valve drive, configuration with rotary seal model 99