Search results for '912-914 INTAKE MANIFOLD'

a – For installation of cylinder on the piston 67.5 mm;
b – For installation of cylinder on the piston 72 mm;
c – To hold the fan;
d – For aligning of cylinders at the intake flange;
e – For crankshaft bearing PTO side;
f – For positioning of crankshaft bearing PTO side;
g – For centering of the stator plate;
h – For piston pin 18 mm;
i – For installation of piston pin circlip 18 mm;
j – For the engine;
k – Without ignition and externals

a – RED 67.50 MM - 67.51 MM, GREEN 67.51 - 67.52 MM;
b – Cylinder PTO side;
c – Cylinder MAG side

b – For mixture lubrication;
c – For oil pump version

b – For mixture lubrication;
c – For oil pump version

a – For cylinder;
b – For cylinder exhaust flange;
c – For rotary valve shaft;
d – For ball bearing, rotary valve shaft;
e – For oil seal rotary valve shaft (wihout oil pump), intake side;
f – For oil seal rotary valve shaft (with oil pump), intake side;
g – For inner oil seal rotary valve shaft, water pump side;
h – For outer oil seal rotary valve shaft, water pump side;
i – To press in the rotary seal;
j – For rotary valve timing;
k – To pull out the rotary seal - the inner steel bushing of the rotary seal has to be removed before demounting!;
l – For fitting of piston pin circlip;
m – For fitting of piston pin circlip (monohook circlip);
q – To press in the rotary seal 850942 with the insertion jig

A – Loctite 221

a – For configuration without oil pump

H – Oil filter

d – See Service Instruction SI-912-017 current issue